Logo

B2932 Engine Trouble Code

Meaning of B2932 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B2932 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B2932 code is occuring now you should check B2932 repair processes.
Now don't ask yourself; What should you do with B2932 code ?
The solution is here :

B2932 Possible Solution:

B2932 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B2932 Code Meaning :

B 2 9 3 2
OBD-II Diagnostic Body (B) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Injector Circuit Malfunction - Cylinders Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) Glow Plug/Heater Circuit 'A' Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B2932 OBD-II Diagnostic Body (B) Trouble Code Description

B2932 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For B2932 Code

The reason of B2932 OBD-II Engine Trouble Code is Injector Circuit Malfunction - Cylinders.

B2932 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.